Used these on my wheelchair. A bit of a pain to put on but adds a personalized flare and I get tons of compliments!

I love the colors that it gave to my wheelchair.

Really nice makes a huge difference! Definitely worth the few dollars! They are a bit a pain in the rear to put on though. They are like straws that have cuts all the way down on one side and you have to open the ends and put it on the spoke and then press and slide the rest on. Take about a hour to do both rims.

These only took a few minutes to install and fit perfectly on my wheelchair. It was as a cheap way to spice up my chair without being permanently committed to a color. Will buy again!

Your browser does not support HTML5 video.

 Had no problem with install other then killed my back setting on cold garage floor in temperatures of 10 degrees.You can install these with frozen fingers!My Yammie is looking so much better, Little by little.I like the white but I need more color on my rims. So I bought another set. This time blue I think I will like that color on the bike better. I will update this review again after I install the blue straws.These was shipped fast, I got these in like just a day!

 Had no problem with install other then killed my back setting on cold garage floor in temperatures of 10 degrees.You can install these with frozen fingers!My Yammie is looking so much better, Little by little.I like the white but I need more color on my rims. So I bought another set. This time blue I think I will like that color on the bike better. I will update this review again after I install the blue straws.These was shipped fast, I got these in like just a day!

There is definitely a technique to installing, but I was able to get the covers cut to length and installed on my CRF150RB and the rear wheel of my CRF450R in about two hrs....that’s including the time to figure out best way to install. Pretty easy once you get the technique down...open one end slightly and put over spoke, then hold with you thumb/finger and start sliding it down towards the wheels hub while you thumb guides the cover onto the spoke. Quality is as expected and color matches well to OEM Honda red. We will see how they hold up to some MX tracks/ trails...prob good not to hit them hard with pressure washer either when washing bike...but we will see!

Very tedious to install but they add a nice pop of color

Took me about 2-3 hours to install these on my 2019 Yamaha xt250. I have super long nails so I was able to slide my nail between the slits and lay them on the spokes that way. They thicker and more snug than I was expecting and I’m happy for that!They’re cheap and made my bike look a lot better! Exactly what I wanted. I had only 1 leftover so make sure if you have to cut them to fit, you don’t mess too many up because I used every single one I got and only had 1 spare in case of any mess ups.